ParkZone Super Cub PNP Manual de Instruções Página 1

Sport CubInstruction Manual / Bedienungsanleitung Manuel d’utilisation / Manuale di Istruzioni

ENThe CG location is 63 - 66mm back from the leading edge of the wing at the root. Make sure the fl ight battery is secured using the hook and loop st

ENAS3X Control Direction TestPerform the Control Direction Test to ensure the aircraft responds cor-rectly to your transmitter. Once you are sure the

ENConsult local laws and ordinances before choosing a fl ying location. Range Check your Radio SystemAfter fi nal assembly, range check the radio system

ENMotor ServiceDisassembly CAUTION: Always disconnect the fl ight battery from the aircraft before removing the propeller. 1. Remove the screw (A) an

ENProblem Possible Cause SolutionAircraft will not re-spond to throttle but responds to other controlsThrottle not at lowest position or throttle trim

ENWhat this Warranty CoversHorizon Hobby, LLC. (“Horizon”) warrants to the original purchaser that the product purchased (the “Product”) will be free

ENDeclaration of Conformity(in accordance with ISO/IEC 17050-1) No. HH2014041002Product(s): Sport Cub BNFItem Number(s): PKZ6880 Equipment cla

ITReplacement Parts • Ersatzteile • Pièces de rechange • Pezzi di ricambioPart # | NummerNuméro | CodiceDescription Beschreibung Description Descrizio

Optional Parts • Optionale Bauteile • Pièces optionnelles • Pezzi opzionaliPart # | NummerNuméro | CodiceDescription Beschreibung Description Descrizi

© 2014 Horizon Hobby, LLC ParkZone, E-flite, HobbyZone, Prophet, EC3, DSM, DSM2, DSMX, Z-Foam, Bind-N-Fly, the BNF logo, Plug-N-Playand ModelMatch a

ENNOTICEAll instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, LLC. For up-to-dat

ENTo register your product online, visit www.parkzone.comBox Contents ...

ENBattery ChargingIMPORTANT: The AR636 receiver installed in the Bind-N-Fly aircraft has been pre-programmed for operation in this aircraft. Refer to

ENBattery Selection• We recommend the E-fl ite® 1300mAh 11.1V 3S 20C Li-Po (EFLB13003S20). • If using another battery, the battery must be at least a

ENLanding Gear Installation1. Install 2 tires (A) on the strut (B) using 2 wheel collars (C) and 2 set screws (D). Tighten the set screws on the fl a

ENWing Assemby and InstallationAssembly1. Install the vortex generators (A) in the wing channels (B) by using double-sided tape (C). CAUTION: DO NOT

ENFactory SettingsHorns ArmsElevatorRudderAileronsControl Horn and Servo Arm SettingsThe table to the right shows the factory settings for the control

ENTransmitter SetupIMPORTANT: The AR636 receiver installed in the Bind-N-Fly aircraft has been pre-programmed for operation in this aircraft. Refer to