ParkZone F4U-1A Corsair Manual de Instruções Página 10

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 22
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 9
EN
Turntheclevisonthelinkagetochangethelengthofthelinkage
betweentheservoarmandthecontrolhorn.
• Pullthetubefromtheclevistothelinkage.
• Carefullyspreadtheclevis,theninserttheclevispinintothe
desired hole in the control horn.
• Movethetubetoholdtheclevisontothecontrolhorn.
Afterbindingatransmittertothemodelreceiver,setthetrimsand
sub-trimsto0,thenadjusttheclevisestocenterthecontrolsurfaces.






Flythemodelatfactorysettingsbeforemakingchanges.Forpilotswho
wishformorecontrolthrow,adjustthepositionofthelinkagesontheservo
armsandcontrolhornsforincreasedtravel.


  

Horns


1. Slidethehorizontaltailtubeintotheholeinthe
rear of the fuselage.
2. Installtheleftandrighthorizontaltailsontothe
fuselageasshown.Ensurethecontrolhorn
facesdown.
3. Apply four pieces of tape to the fuselage mounts
(one on the top and bottom of each half of the
horizontaltail).
4. Attachtheclevistotheelevatorcontrolhorn
(seeinstructionsforclevisconnection).
5. Whenneeded,disassembleinreverseorder.
Intallation
1. Install the left landing gear door hinge ()
(markedL)inthewingclampasshown.
2. Install the left landing gear plate (A)(marked
withanL)inthewingusingfourscrews().
3. Install the left landing gear strut in the plate as
shown.
4. Installtheleftcover(C)(markedL)onthestrut
(D)usingtwoscrews(E).
5. Installthewheelonthestrutusingthecollar.
Makesurethebushingsideofthewheelis
towardthebendinthestrut.
6. Tightenthesetscrew(F)inthecollar.Usea
smallamountofthreadlocktoholdthesetscrew
in the collar.
7. Install the right landing gear the same as the
left landing gear.

Whenneeded,disassembleinreverseorder.
3X10mm(2)
3X15mm(4)
A
C
D
E
3X4mm(1)
F

Vista de página 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 21 22

Comentários a estes Manuais

Sem comentários